Look at the FAQ and Trouble Shooting Guide for suggestions.

Check out the Altfuel site for discussion groups and more suggestions.

List of needed items for conversion:        

    Preheater block with cartridge heater  and nozzle                     

4” tubing (if yours is not long enough) use 4” truck exhaust pipe; use Beckett flange, number 5432 from Patriot Supply

Retention head (ckBurners, Kagi, or other)

Digital temperature controller (eBay, or from ckBurners)

Relay (McMaster-Carr part number 7098K52) or any 10 amp rated with a 120v coil

 Miscelaneous fittings

 Float tank (you can make one using a 3/8” float valve (McMaster-Carr part number 4652K11)

   Larger or second junction box for primary safety and temperature controller, suggested size is 4 11/16” x 4 11/16” from Home Depot

10-32 all thread and nuts for electrodes

 Air solenoid 120v coil, 1/8” orifice, direct acting is better. If your burner had a solenoid for oil, you can re-use that for air. Otherwise ckBurners recommends McMaster-Carr part number 8077K66.

 Air pressure regulator (any Home Depot) or McMaster-Carr part number 6746K27

  0-15 psi gauge (McMaster-Carr part number 3846K119)

 Air compressor capable of 3cfm at 20psi

        If you need new electrodes, use Beckett part number 5780 from           Patriot Supply